QC/QC+/IC+ Series

QC Series Centrifugal pumps are built and designed in compliance with 3A Standards, with the following characteristics:
• Open Impeller
• Volute casing with central suction
• Fittings: Clamp (standard), Flange, NPT thread, Weld, Bevel Seat and DIN
• 304 stainless steel support legs and bracket kit
• Manufactured in compliance with NEMA (American) and IEC (European) standards
• Can operate at both 60Hz and 50Hz
• 304 stainless steel adaptor
• All parts in contact with the product are made from 316L stainless steel.

The QC pumps are made with the traditional coupling system (Puriti, Tri-Clover, Waukesha "C" Series), through the use of a pin, however, at Q-PUMPS, we have developed the QC Plus Pump (QC+), which facilitates and accelerates the entire assemble of QC Series pumps, making it easier to hold the stub shaft to the motor using a collar. The stub shaft plus is threaded, offering a tighter fit of the impeller, through the use of a key and nut, and together, encompassing an assembly specially designed to maintain the conditions required by 3A sanitary standards. Over the long term, the QC+ pump coupling is more effective that the regular pump. The traditional QC series pump is easily interchangeable with the QC+ pump, with the Kit Plus.


QC sanitary pumps are mainly used handling products with a viscosity of less than 500cps (primarily soft liquids): like dairy products, juice, soft drinks, wine, beer, purified water, oil, alcohol, vaccines, etc.

This pump can handle low pressures and high volumetric flows of up to 1,200gpm.

Select your pump

Reference Data

Caudal: 1,200 gpm

Presión: 310ft

Viscosidad: 600cps

Temperatura: 180ºC / 356ºF